Saturday 25 July 2020

3 Ton Plus

The plan for the Maenofferen tank waggon was always to try and use a 3 ton slate waggon chassis, the question was always whether the wheelbase would be right or if it would need a lot of hacking about to make it fit.

Himself provided the chassis after purchasing a pack of Dundas waggon kits to renew our fleet and when I compared it with the drawing I was delighted to find the axle boxes in precisely the same place as on the regular waggons.


The tank waggon, is longer, however, but all the extra length is at the ends rather than in the middle, so it wasn't difficult to add some styrene extensions.

The other thing I did was to thin down the main base of the chassis as it was a little too thick, just by rubbing it over fine grade sand paper.

Fortunately the wagon doesn't have anything as sophisticated as brakes, so there's very little that required to be done underneath except extend the frames.


Up top, on the tank, I've made up the tank filler using my ever-handy selection pack of styrene tubes and formed the domed top of the cap with a drop of resin.





 

No comments:

Post a Comment